Dot1X Timeout Tx-Period - Alcatel OmniStack LS 6248 User Manual

4
Command Line Interface
Parameters
• seconds — Specifies the time in seconds that the device remains in the
quiet state following a failed authentication exchange with the client.
(Range: 0 - 65535 seconds)
Default Setting
Quiet period is 60 seconds.
Command Mode
Interface Configuration (Ethernet) mode
Command Usage
During the quiet period, the device does not accept or initiate authentication
requests.
The default value of this command should only be changed to adjust for
unusual circumstances, such as unreliable links or specific behavioral
problems with certain clients and authentication servers.
To provide a faster response time to the user, a smaller number than the
default value should be entered.
Example
The following example sets the number of seconds that the device remains in the
quiet state following a failed authentication exchange to 3600.
Console(config)#
Console(config-if)#
Related Commands
dot1x port-control
dot1x re-authentication
dot1x timeout re-authperiod

dot1x timeout tx-period

dot1x max-req
dot1x timeout supp-timeout
dot1x timeout server-timeout
show dot1x
show dot1x users
dot1x timeout tx-period
The
dot1x timeout tx-period
number of seconds that the device waits for a response to an Extensible
Authentication Protocol (EAP)-request/identity frame from the client before
270
interface ethernet
dot1x timeout quiet-period
Interface Configuration mode command sets the
1/e16
3600