Defining Dynamic Forwarding Database Entries; Figure 3-92. Static Addresses Page - Alcatel OmniStack LS 6248 User Manual

MAC address and VLAN, then click Apply.
CLI – The following is an example of the CLI commands used to define static
addresses:
Console(config)#
4-664
Console(config-if)#
permanent
4-314

Defining Dynamic Forwarding Database Entries

The Dynamic Address Table contains the MAC addresses learned by monitoring the
source address for traffic entering the switch. When the destination address for
inbound traffic is found in the database, the packets intended for that address are
forwarded directly to the associated port. Otherwise, the traffic is flooded to all ports.
The Dynamic Addresses Page contains parameters for querying information in the
Dynamic MAC Address Table, including the interface type, MAC addresses, VLAN,
and table storing. The Dynamic MAC Address table contains information about the
aging time before a dynamic MAC address is erased, and includes parameters for
querying and viewing the Dynamic MAC Address table. The Dynamic MAC Address
table contains address parameters by which packets are directly forwarded to the
ports. The Dynamic Address Table can be sorted by interface, VLAN, and MAC
Address.

Figure 3-92. Static Addresses Page

interface vlan
bridge address
Defining the Forwarding Database
2
3aa2.64b3.a245
ethernet
1/e16
3
189