Configuring Ntp - 3Com 3CRWX120695A Reference Manual

1 Do one of the following:
2 Click on a row in the IP Address column.
3 Change the IP address in the row to the address of the DNS server.
4 If this server is the primary DNS server for the switch, select the checkbox
5 You can designate only one DNS server as the primary DNS server. All
6 To add more DNS servers, repeat step 1 through step 4 for every server.
7 Do one of the following:

Configuring NTP

Adding DNS Servers
To add a DNS server:
Open the WX Switch wizard, then select DNS under IP Services in the
organizer list of the System and Administrative page.
In the Organizer panel, select IP Services under a WX switch or
Domain Policies, then select Edit > Properties. The Modify IP Services
wizard appears. Click on DNS at the top of the wizard.
in the Primary column.
other DNS servers are secondary servers.
You can add a total of six DNS servers.
Go to "Configuring NTP".
Select another item in the WX Switch wizard, if you are using this
wizard.
Click Finish to close the wizard and save changes.
You can configure a WX switch to use the Network Time Protocol (NTP)
to automatically set the system date and time. NTP polls network time
servers at regular intervals and synchronizes the system date and time
with the servers. By default, NTP is not enabled. You can specify up to
three NTP servers.
If NTP is configured on a system whose current time differs from the NTP
server time by more than 10 minutes, convergence of the WX time can
take many NTP update intervals. 3Com recommends that you set the
time manually to the NTP server time before enabling NTP to avoid a
significant delay in convergence.
Configuring IP Services 247