Table of Contents
Advertisement
Section - Configuration
This page will allow you to change the Administrator and User passwords. You can also enable Remote Management. There are two
accounts that can access the management interface through the web browser. The accounts are admin and user. Admin has read/write
access while user has read-only access. User can only view the settings but cannot make any changes. Only the admin account has
the ability to change both admin and user account passwords.
Admin Password:
Enter a new password for the Administrator Login Name. The
administrator can make changes to the settings.
User Password:
Enter the new password for the User login. If you login as the User,
you can only see the settings, but cannot change them.
Gateway Name:
Enter a name for the DIR-68 router.
Remote
Remote management allows the DIR-68 to be configured from
Management:
the Internet by a web browser. A username and password is still
required to access the Web-Management interface. In general, only
a member of your network can browse the built-in web pages to
perform Administrator tasks. This feature enables you to perform
Administrator tasks from the remote (Internet) host.
Remote Admin
The port number used to access the DIR-68.
Port:
Example: http://x.x.x.x:8080 where x.x.x.x is the Internet IP address
of the DIR-68 and 8080 is the port used for the Web Management
interface.
Inbound Filter:
This section will list any rules that are created. You may click the
Edit icon to change the settings or enable/disable the rule, or click
the Delete icon to remove the rule.
D-Link DIR-68 User Manual
Administrator Settings
55
Advertisement
Table of Contents
