D-Link DIR-68 User Manual page 37

Section  - Configuration
This will allow you to open a single port. If you would like to open a range of ports, refer to page 5.
Name:
Enter a name for the rule or select an application from
the drop-down menu. Select an application and click <<
to populate the fields.
IP Address:
Enter the IP address of the computer on your local
network that you want to allow the incoming service to.
If your computer is receiving an IP address automatically
from the router (DHCP), you computer will be listed in
the "Computer Name" drop-down menu. Select your
computer and click <<.
Private Port/
Enter the port that you want to open next to Private
Public Port:
Port and Public Port. The private and public ports are
usually the same. The public port is the port seen from
the Internet side, and the private port is the port being
used by the application on the computer within your
local network.
Protocol Type:
Select TCP, UDP, or Both.from the drop-down menu.
Inbound Filter:
Select Allow.All (most common) or a created Inbound
filter. You may create your own inbound filters in the
Advanced.>.Inbound.Filter page.
Schedule:
The schedule of time when the Virtual Server Rule will
be enabled. The schedule may be set to Always, which
will allow the particular service to always be enabled.
You can create your own times in the Tools > Schedules
section.
D-Link DIR-68 User Manual 7