Administrator Settings - D-Link DWR-112 User Manual

Section 3 - Configuration
To access this page, click on TOOLS in the top bar, then click ADMIN in the left-hand bar. This page will allow you to
change the Administrator and User passwords. You can also enable Remote Management. There are two accounts
that can access the management interface through the web browser. The accounts are admin and user. Admin has
read/write access while user has read-only access. User can only view the settings but cannot make any changes.
Only the admin account has the ability to change both admin and user account passwords.
Admin
Enter and confirm a new password for
Password:
the Administrator Login Name. The
administrator can make changes to the
settings.
Enable
Check this box to enable graphical
Graphical
authentication. The device supports this
Authentication:
function to prevent phishing.
Enable Remote
Remote management allows the DWR-112
Management:
to be configured from the Internet by a web
browser. A username and password is still
required to access the Web-Management
interface. In general, only a member of your
network can browse the built-in web pages
to perform Administrator tasks. This feature
enables you to perform Administrator tasks
from the remote (Internet) host.
Remote Admin
The port number used to access the DWR-
Port:
112.
Example: http://x.x.x.x:8080 whereas
x.x.x.x is the Internet IP address of the
DWR-112 and 8080 is the port used for the
Web Management interface.
D-Link DWR-112 User Manual

Administrator Settings

73