FINAL DRIVE
CV JOINT SERVICE
CV Joint Replacement
1.
Remove clamps from rubber boot(s) using the CV Boot
Clamp Pliers (PN 8700226) (A).
A
NOTE: Photo below is shown without shaft for
clarity. Wipe grease away from recess in CV joint
inner hub to locate snap ring
Snap Ring Located in recessed area
2.
Open the snap ring using a snap ring pliers or small needle
nose pliers. Tap CV housing off shaft with a soft faced
7.24
- www.instant-manuals.com -
hammer while holding snap ring open.
Tap CV housing
off shaft
3.
Place a new snap ring in the groove of the CV joint inner
hub, with tabs facing the shaft as shown.
Snap Ring
Spread ends of snap ring
to remove joint from
Tabs face shaft