Chapter 8)
8. Front prop shaft (4x4 models) (Drive pin out at front
gearcase, pull shaft back, then forward. Refer to Drive
Chapter)
9. Remove transmission linkage rod (A) and vent hose
(B)
10. Disconnect
gear
indicator
transmission)
B
11. Disconnect speed sensor from transmission (left rear
side).
12. Rear fuel tank bracket
- www.instant-manuals.com -
13. CVT air intake and exhaust ducts
14. Remove carburetor. Insert a clean shop towel into the
15. Remove exhaust head pipe.
16. Starter motor positive (+) and negative (-) cables at
switch
harness
(at
A
carburetor flange to prevent dirt from entering the
intake port.
starter motor.
ENGINE
3.11