STARTER DRIVE CLUTCH REMOVAL/
INSPECTION
1. Remove recoil housing bolts and remove housing.
2. Remove the starter drive clutch and washer by pulling
the shaft and tilting the gear slightly.
3. Measure the OD of the starter drive shaft on both ends
for out-of-round.
4. Measure the ID of the bushings in the recoil housing
and in the crankcase (A) in two directions 90
determine if out-of-round. Replace worn bushings.
5.
Inspect gear teeth on starter drive. Replace starter
drive if gear teeth are cracked, worn, or broken.
- www.instant-manuals.com -
CAM CHAIN DRIVE SPROCKET REMOVAL /
INSPECTION
1. Remove recoil housing, flywheel, flywheel key, and
2.
o
apart to
A
3. Remove cam chain drive sprocket and Woodruff key
4. Inspect sprocket teeth for wear or damage.
5. Inspect Woodruff key for wear.
stator.
Using the Slotted Nut Socket, remove the crankshaft
slotted nut by turning it clockwise. NOTE: Slotted nut
is left hand thread.
REMOVE
Slotted Nut Socket
(PN 2871293-A)
from crankshaft.
Visually inspect for
tooth wear or damage
ENGINE
3.29