Polaris Hawkeye Repair Manual page 158

FINAL DRIVE
new o-ring and torque bolts to 14 ft. lbs (19 Nm).
4. Install the output hub (A) into the gearcase housing. Apply
a small amount of grease to the seal and seal surface as this
will aid assembly. The output hub should spin freely.
A
7.16
- www.instant-manuals.com -
5.
14 ft.lbs. (19 Nm)
6.
7.
Install the rollers and roll cage into the ring gear. Insert the
rollers as the roll cage is installed, installing the lower row
first and then the upper row.
Install the ring gear over the output hub and into the output
cover. Insert the backlash pad (G) and set assembly
upright..
Install the armature plate (D) onto the ring gear. Verify the
plate tabs are places into the slots on the roller cage.
NOTE: Verify backlash plate stays in place.
D
D
G