Engine Installation Notes - Polaris Hawkeye Repair Manual

26. Support engine and remove (9) transmission-to-
engine bolts.
IMPORTANT: DO NOT LIFT ENGINE BY THE
STARTING CLUTCH SHAFT!

ENGINE INSTALLATION NOTES

After the engine is installed in the frame, review this checklist
and perform all steps that apply:
General Items
• Install previously removed components using new
gaskets, seals, and fasteners where applicable.
• Perform checks on fluid levels, controls, and all
important areas on the vehicle as outlined in the daily
pre-ride inspection checklist (refer to Chapter 2).
CVT System
• Clean clutch sheaves thoroughly and inspect inlet
and outlet ducts for proper routing and sealing.
• Inspect drive and driven clutch as described in
chapter 8.
Transmission
• Inspect transmission operation.
Exhaust
• Replace exhaust gaskets. Seal connections if
necessary with high temp sealant.
• After running the engine, verify all bolted exhaust
connections are tight and in good condition.
Engine Mount Torque
• Inspect all engine mount fasteners and verify they
are tightened properly
- www.instant-manuals.com -
Engine Break In Period
4 Cycle Engine Break-In Period is defined as the first 10
hours of engine operation or 2 full tanks of fuel.
• Use only Polaris Premium 4 All Season Synthetic
Oil, or API certified "SH" oil.
• Use fuel with a minimum octane of 87 (R+M)/2
method.
• Change break-in oil and filter at 20 hours or 100
miles, whichever comes first.
ENGINE
3.13