Setting The Clock - Sharp CD-CH1500 Operation Manual

Audio tower system
Hide thumbs Also See for CD-CH1500:
Table of Contents

Advertisement

Setting the Clock

In this example, the clock is set for the 12-hour (AM12:00) display.
1
Press the POWER button to turn the power on.
2
Press the MENU button.
3
Turn the jog dial to select "CLOCK" and within 10 seconds, press
the ENTER button.
4
Turn the jog dial to select the 12-hour or 24-hour display and
within 2 minutes, press the ENTER button.
"AM 12:00"
The 12-hour display will appear. (AM 12:00 - PM 11:59)
"AM 0:00"
The 12-hour display will appear. (AM 0:00 - PM 11:59)
"0:00"
The 24-hour display will appear. (0:00 - 23:59)
Note that this can only be set when the unit is first installed or it has been reset.
[Refer to "Clearing all the memory (reset)" on page 30 for details.]
5
Turn the jog dial to adjust the hour and within 2 minutes, press
the ENTER button.
When the 12-hour display is selected, "AM" will change automatically to "PM".
6
Turn the jog dial to adjust the minutes and within 2 minutes, press
the ENTER button.
The hour will not advance even if minutes advance from "59" to "00".
The clock starts from "0" second. (Seconds are not displayed.)
The time display will disappear after a few seconds.
To confirm the time display:
[When the unit is in the stand-by mode]
Press the DISPLAY button on the remote control.
The time display will appear for about 3 seconds.
[When the power is on]
Press the MENU button.
The time display will appear for about 10 seconds.
Note:
"CLOCK" will appear or time will flash at the push of the DISPLAY button when the AC
power supply is restored after a power failure or unplugging the unit.
Reset the clock as follows.
To reset the clock:
[When time is flashing]
1. Press the POWER button.
2. Press the MENU button.
3. Press the ENTER button.
4. Perform "Setting the Clock" from step 5.
[When "CLOCK" appears]
Perform "Setting the Clock" from the beginning.
To change the 24-hour or 12-hour display:
1. Clear all the programmed contents.
[Refer to "Clearing all the memory (reset)" on page 30 for details.]
2. Perform "Setting the Clock" from the beginning.
15

Advertisement

Table of Contents
loading

Table of Contents