Enhancing Your Stereo System - Sharp CD-CH1500 Operation Manual

Enhancing Your Stereo System

The connection cord is not included.
Purchase a commercially available cord as shown below.
RCA cord
28
Red White
White
VCR, DVD, etc.
To the line output jack
Red
Listening to the playback sounds from VCR,
DVD, etc.
1
. Use a connection cable to connect the unit to the AUX IN jacks.
When using video equipment, connect the audio output to this unit and the video
output to a television.
2
. Press the POWER button to turn the power on.
3
. Press the AUX button to select "AUX".
4
. Operate the VCR, DVD, etc.
5
. Adjust the input level from VCR, DVD, etc. using the 3 or 2 button.
The "OVER" indicator should not light at the maximum level.
–2
Note:
To prevent hum interference, place this unit away from a television.
To record on a tape
1
. Insert a cassette in the cassette compartment.
2
. Press the AUX button to select "AUX".
3
. Press the REC PAUSE I6 button.
4
. Operate the VCR, DVD, etc.
5
. Adjust the input level from VCR, DVD, etc. using the 3 or 2 button.
The "OVER" indicator should not light at the maximum level.
–2
6
. Press the 06 button to record on side A, or the 1 button for side B.
Headphones
Before plugging in or unplugging the headphones, reduce the volume.
Be sure your headphones have a 1/8" (3.5 mm) diameter plug and are between 16
ohms and 50 ohms impedance. The recommended impedance is 32 ohms.
Plugging in the headphones disconnects the speakers automatically. Adjust the
volume using the VOLUME buttons.
0 +4
0 +4