Naming Station Presets; Listening To Station Presets - Pioneer Elite VSX-90TXV Operating Instructions Manual

Using the tuner
06

Naming station presets

For easier identification, you can name your station
presets.
1 Choose the station preset you want to name.
See Listening to station presets below for how to do this.
2 Press T.EDIT (TUNER EDIT).
The display shows STATION NAME, then a blinking
cursor at the first character position.
3 Input the name you want.
Choose from the following characters for a name up to
four characters long.
ABCDEFGHIJKLMNOPQRSTUVWXYZ
abcdefghijklmnopqrstuvwxyz
0123456789
∗
!"#$%&'() +,–./:;<=>?@[ \ ]^_{|} ˜ [space]
• Use the ST / buttons (remote) to select
characters.
• Press ENTER to confirm a character. If no character
is input, a space is input.
• The name is stored when ENTER is pressed after
choosing the fourth character.
Tip
• To erase a station name, simply repeat steps 1 to 3
and input four spaces instead of a name.
• Once you have named a station preset, you can press
DISP when listening to a station to switch the display
between name and frequency.

Listening to station presets

You will need to have some presets stored to do this. See
Saving station presets above if you haven't done this
already.
1 Press TUNER to select the tuner.
2 Press CLASS to select the class in which the station
is stored.
Press repeatedly to cycle through classes A, B and C.
Press ST / to select the station preset you
3
want.
• You can also use the number buttons on the remote
control to recall the station preset.
34
En