06
More tuner features
Chapter 6
More tuner features
Memorizing stations
You can save up to 30 station presets so that
you always have easy access to your favorite
stations without having to tune in manually
1
each time.
Manually saving station presets
1
Tune to an AM or FM radio station.
For the FM band, select mono or auto-stereo
reception as necessary. This setting is saved
along with the preset.
2
Press SYSTEM SETUP , use
choose 'Tuner Setup' then press ENTER .
3
Use
to choose 'ST. Memory' then
press ENTER .
4
Use
to select the station preset you
want then press ENTER .
Automatically saving station presets
1
Press SYSTEM SETUP , use
choose 'Tuner Setup' then press ENTER .
2
Use
to choose 'Auto Preset' then
press ENTER .
Auto tuning starts in the FM band, stopping
when a strong signal is received.
3
When auto tuning stops at a station, press
ENTER to save the station as a preset, or press
CLEAR to continue without saving.
Auto tuning resumes. After the FM band is
finished, auto tuning continues in the AM
band. Press
(stop) anytime to exit.
Note
1 If the system is unplugged, saved stations will remain for several days, after which you'll have to save them again.
2 Press DISP/CHARA to switch between the station name and frequency displays.
3 You can also use the number/character buttons to do this.
24
En
Auto tuning stops automatically after the AM
band is finished, or after the limit of 30 presets
has been reached. When this happens, the
tuner automatically switches to preset ST-1.
Naming station presets
You can name station presets for easy
identification.
1
Press FM/AM repeatedly to select the
station preset mode.
The display shows ST.
2
Use the ST +/– buttons to select a station
3
preset.
to
3
Press SYSTEM SETUP , use
choose 'Tuner Setup' then press ENTER .
4
Use
ENTER .
5
Use
characters.
• Press DISP/CHARA to switch between
uppercase and lowercase letters. Press
to
MARK to select symbols.
• If you make a mistake, press
to the character and
• Press CLEAR to delete a character or
(stop) anytime to exit without saving.
6
Press SYSTEM SETUP when you're done.
2
to choose 'ST. Name' then press
and ENTER to input up to 11
3
to change it.
to
to go back