Status Lights - Kodak ESP 9 ALL-IN-ONE PRINTER User Manual

Printer Overview

Status lights

The tables below describe the meaning of each light and condition, and offer tips on what
action to take.
Light Status
Off
Blinks
On
Most power supplies used with this ESP All-in-One printer are equipped with a status light which
illuminates when electricity is appied. If you cannot determine if the power supply is working properly
contact Kodak Service & Support for assistance.
Light Status
Off
On
18
On/Off Light
Cause
The printer is turned off.
The printer does not have power
applied.
The printer is initializing or busy.
The printer is ready.
Printer Power Cord Light
Cause
The printer power cord is not
properly connected to the printer.
The electrical power cord is not
properly connected to your electrical
outlet.
The electrical outlet has no power.
The problem may lie with the power
supply.
The power supply is supplying power
to the printer.
Action/Solution
Press On/Off to turn the printer on.
Ensure that the printer power cord is
properly plugged into the back of the
printer.
Verify that the power supply and or
power cord LED is lit.
Check that the power supply is
connected to the power cord, and that
it is properly connected to the
electrical outlet.
None. Allow the printer to finish the
initialization process.
None.
Action/Solution
Reconnect the printer power cord plug
to the printer.
Reconnect the cord to the electrical
outlet. Ensure that the electrical
power cord is fully connected to the
alternating current (AC) adapter at
the end of the printer power cord.
Plug a working device into the wall
outlet to test it, or have it checked by
an electrician.
Check the power supply status light, if
available. As needed, visit Kodak.com
for additional troubleshooting steps,
or contact Kodak Service & Support.
None.
Kodak ESP 9 Printer User Guide