Print too light
.
Caution:
All-in-One printer.
•
Make sure the paper is loaded with the print side face down. Reload it if necessary.
•
Try taking the picture again with the flash off. Refer to your camera user's guide for
details.
•
Adjust the exposure compensation on your camera and try taking the picture again.
Refer to your camera user's guide for details.
•
Edit the picture on your computer.
Printing slow
Note:
the printhead from overheating.
•
Make sure the printer is not placed in direct sunlight or is not operating in a high-
temperature environment (higher than 95° Fahrenheit or 35° Celsius).
•
Close any unnecessary software applications.
•
Make sure your computer meets the minimum system requirements. Upgrade your
system if necessary.
Printing stops
Printing stops during mid-print. Paper stops feeding, and status light may blink.
Caution:
All-in-One printer.
To check the paper:
1
Remove any loose paper from the printer. Check the paper access door in the rear of the
printer.
2
Inspect the paper supplies and reload with new paper if necessary.
3
Carefully "fan" the paper to keep the sheets from sticking together.
4
Reload the paper tray. Do not overload.
Start
5
Press
Kodak ESP 7 Printer User Guide
For best results, use Kodak paper and ink cartridges for your Kodak
When printing a large number of prints, printing may slow down to prevent
For best results, use Kodak paper and ink cartridges for your Kodak
to continue.
Chapter 9
83