Setting Up Your Printer
USB to Ethernet setup
To convert the USB connection from a PC to an Ethernet connection:
1
Disconnect the printer from the computer.
2
Use the Windows Control Panel to delete the printer from you computer.
3
Connect the printer to the network (LAN port on Router) with an Ethernet cable.
4
Run the Kodak Printer Network Setup Utility. This is located on the
Programs
procedure is not necessary.
Connect via Network - Ethernet cable
5
Select
should be detected and driver installations begin. If you have more than one printer
connected to your network, select the printer then click
6
After the driver installation completes, click
7
The printer will be named Kodak ESP 7-XXXX where XXXX is a number unique to your
printer.
Wi-Fi to Ethernet
To convert the Wi-Fi connection from a PC to an Ethernet connection:
1
Connect the printer to the network (LAN port on the Router) with an Ethernet cable.
Ethernet to Wi-Fi
To convert the Ethernet connection from a PC to a Wi-Fi connection.
1
Disconnect the Ethernet cable from the printer.
2
Configure the wireless network from the printer front panel. See "Configuring a wireless
network connection" on page 24.
Menu.
3
Press
4
Press
View Network Configuration
5
Select
For Macintosh
USB to Wi-Fi
To convert the USB connection from a Macintosh to a wireless network connection:
1
Disconnect the printer from the computer.
2
Use the Windows Control Panel to delete the printer from you computer.
3
Configure the wireless network from the printer front panel. See "Configuring a wireless
network connection" on page 24.
Menu.
4
Press
32
Kodak
Kodak Printer Network Setup Utility
>
>
Network Settings
until
, then click
Done
to proceed.
menu is selected, and then press
and confirm you have an IP address.
Kodak ESP 7 Printer User Guide
Start
All
>
. If Macintosh, this
Next
to proceed. The printer
Next.
OK
.