Section 3
Reading 2D Code
Reading 2D Code
■ Trigger Buttons
The trigger buttons on the left and right side of the Handheld 2D Code Reader perform
the same operations. When a trigger button is pressed, the 2D Code Reader will start
reading code.
■ Trigger Mode
Triggers can be input two different ways. Select the input method to suit the required
application.
◆ Level Trigger (Default)
Press and hold the trigger button to read code continuously until code is successfully
read or until the trigger button is released.
Trigger button ON
Trigger button OFF
Reading status
◆ Alternate Trigger
Press the trigger button once to read code continuously until code is successfully read
or until the trigger button is pressed again.
Trigger button ON
Trigger button OFF
Reading status
■ Zoom Lever
The zoom lever is used to change the field
of vision to suit the size of the code to be
read.
Model
V400-H101
V400-H201
V400-H101/201
34
User's Manual
Reading
Reading
Setting range
5 mm (TELE) to 10 mm (WIDE)
15 mm (TELE) to 30 mm (WIDE)