Omron V400-H201 User Manual page 24

Section 2
Installation and Connections
Connecting Cables to the Handheld 2D Code Reader
Connect one end of the cable to a personal computer or Programmable Controller before connecting
the other end of the cable to the Handheld 2D Code Reader.
1.
Attach the provided ferrite cores to the cable.
Attach the ferrite cores in two locations; one at the Handheld 2D Code Reader end of the cable, and the other
at the host device end of the cable.
Close the ferrite cores until a click is heard. Separate from the power lines.
2.
Connect the cable.
Grasp the cable plug (part A). Line up the alignment mark
on the plug with the alignment mark on the Handheld 2D
Code Reader connector and push the plug in straight.
Cable
V400-H101/201
22
User's Manual
Ferrite cores
Cable port
D
Plug
C
A
Alignment marks
D
C