Omron NS - REV 12 Setup Manual page 217

• Setting Ethernet Communications Conditions
Setting item
Network Add.
Node Add.
IP address
Sub-net
Default gateway
MAC address
LAN SPEED
FTP
IP Address: Show Table
Note: Do not set the following values for the IP address.
Host ID with all bits set to 0 or 1 (e.g., 192.168.21.0).
Net ID with all bits set to 0 or 1 (e.g., 255.255.21.16).
Subnet ID with all bits set to 1 (e.g., 192.168.255.16).
IP addresses that begin with 127 (e.g., 127.35.21.16).
• Host Settings
This setting is used to display detailed data for hosts connected using Ethernet or Controller
Link. The host type, network address, and node address for each host can also be changed.
3. Press the ETN/CLK Host Display Button. The registered hosts will be displayed in a list.
Function
Sets the network address used for
Ethernet communications.
Sets the local node address.
Sets the local IP address.
Sets the subnet mask of the local node.
Sets the IP router.
Displays the MAC address (device-
specific information to identify each de-
vice connected to the network.)
Selects the method used to set the
Ethernet baud rate.
Selects whether or not to use the FTP
server.
Displays the node numbers and IP ad-
dresses of other nodes connected
through Ethernet.
6-6 Communications Settings
Settings
1 to 127
0 to 254
0.0.0.0 to 255.255.255.255
(See note.)
0.0.0.0 to 255.255.255.255
0.0.0.0 to 255.255.255.255
Read-only.
Automatic switch or fixed
10Base-T
Enable or disable
Node addresses: 1 to 254
IP addresses:
0.0.0.0 to 255.255.255.255
6-43