Omron NS - REV 12 Setup Manual page 94

3-7 Installing the Video Input Unit
Connecting to the Console Port Connector
Use the following method to connect the Video Board's console port connector to the console
connector of an OMRON Vision Sensor (F150-C10V3, F160-C10, F180-C10, F400-C10V2,
F250-C10, V530-R150V2).
1. Insert the socket of the Relay Cable (F150-VKP; see note) into the Video Board's console
port connector.
Note
Removing the Console Port Connector
Use the following method to remove the Relay Cable from the Video Board's console port
connector.
1. Remove the Relay Cable by pulling on the connector as shown below.
3-40
The Relay Cable (F150-VKP) is the cable used to connect the Video Board's console connec-
tor to the console connector of an OMRON Vision Sensor.