Omron NS - REV 12 Setup Manual page 158

5-1 Connecting to Host Via Ethernet
and 7E (1 to 126 decimal).
Set the upper digit using the left rotary switch and the lower digit using the right rotary switch.
The factory setting is 01.
When using automatic generation to convert addresses, set the node number to the same
value as that of the rightmost byte of the local IP address. If the same values cannot be set,
the IP address table method or combination method must be used to convert the addresses.
Setting Local IP Addresses
Set the local IP address with the CX-Programmer or other computer support software. Refer
to the EtherNet/IP Unit Operation Manual (Cat. No. Z909) for details on setting methods.
Ethernet Connectors
This is the connector used to connect the twisted-pair cable to the Ethernet.
• Electrical Characteristics: Conforms to IEEE802.3 standards.
• Connector Layout: RJ45 8-pin modular connector (conforms to ISO8877).
• CV/CVM1-series (-V@) PLCs
Unit for CV500-CPU01-V1, CV1000-CPU01-V1, CV2000-CPU01-V1, CVM1-CPU01-V2,
CVM1-CPU11-V2, and CVM1-CPU21-V2 CPU Units:
Setting Rotary Switches
Set the unit number and node number with the two rotary switches on the front of the Unit.
5-14
Connec-
1
tor Pin
1
2
3
4
8
5
6
7
8
CV500-ETN01
Setting range
01 to 7E (1 to 126 decimal)
Signal name
Send data
Send data −
Receive data +
Not used.
Not used.
Receive data −
Not used.
Not used.
Abbreviation Signal direction
TD+ Output
TD− Output
RD+ Input
− −
− −
RD− Input
− −
− −