Setup Menu ( Setup ); Operating Mode ( Func ) - Omron K3NP - 1998 Operation Manual

Setting Mode

4-2-5 Setup Menu ( setup )

Operating Mode
func
FUNCTION
SETTING
REFERENCE
SETTING
Follow the steps described below to select the f4 elapsed time setting.
EXAMPLE
1, 2, 3...
50
All parameters will be set to default values if any change in made in this parame-
ter, except to those for the communications and protect settings.
f1 : Displays the reciprocal of the time (T) between the moment input A is
turned ON and the moment input B is turned ON after being multiplied by
60.
f2 : Measures and displays the cycle (T) of input A as is.
f3 : Displays the time between the moment input A is turned ON and the mo-
ment input B is turned ON as is.
f4 : Displays the elapsed time (T) of input A.
f5 : Displays the number of pulses of input A counted while input B is ON.
f6 : Displays the number of pulses of input A counted between the moment in-
put B is turned ON and the moment input B is turned ON again.
Setting
Passing speed
f1:
Cycle
f2:
Time difference
f3:
Elapsed time
f4:
Length measurement
f5:
Interval
f6:
Refer to Section 3 Operating Modes.
Set Value LED Display Model
1. Press the Mode Key for more than one second while the setup setup menu
is displayed. The func operating mode setting will appear.
Set Value LED Display Model
2. Press the Shift Key to display f1 for changing. The PROG indicator will flash.
Set Value LED Display Model
Default
f1
Basic Model
Basic Model
Basic Model
Section 4-2