Omron CXONE-ALC-V4 - 10-2010 Operation Manual page 9

About this Manual:
This manual describes the installation and operation of the CXONE-AL@@C-V4/CXONE-AL@@D-V4
Face Plate Auto-Builder for NS. The Face Plate Auto-Builder for NS is a software package used to
automatically build project files for the CS1W-LC001 Loop Control Unit, the CS1W-LCB01 and CS1W-
LCB05 Loop Control Boards, CS1D-CPU@@P Process-control CPU Units, and CJ1W-CPU@@P Loop
Control CPU Units used with NS-series Programmable Terminals. These files are based on the tag
files created using CX-Process Tool.
The project files that are created are configured using the Face Plate Screens for the Loop Control
Unit.
Please read this manual carefully and be sure you understand the information provided before
attempting to install and operate the Face Plate Auto-Builder for NS. Please read the following manuals
carefully and be sure you understand the information provided before setting up the Loop Control Unit/
Board and NS-series PT System
Manuals Related to the Loop Control Unit/Board
Product
CXONE-AL@@C-V4/
CXONE-AL@@D-V4
Face Plate Auto-
Builder for NS
WS02-LCTC1-EV3
CX-Process Tool
CXONE-AL@@C-V4/
CXONE-AL@@D-V4
CX-One FA Integrated
Tool Package
WS02-LCTC1-E
CX-Process Monitor
WS02-LCMC1-E
CX-Process Monitor
Plus
CS1W-LC001
Loop Control Unit
CS1W-LCB01/05
@@
CS1D-CPU
Loop Control Boards
CS1W-LC001
Loop Control Unit
CS1W-LCB01/05
@@
CS1D-CPU
Loop Control Boards
Manual name
Face Plate Auto-Builder
for NS
Operation Manual
CX-Process Tool
Operation Manual
CX-One
Setup Manual
CX-Process Monitor
Operation Manual
CX-Process Monitor Plus
Operation Manual
Loop Control Unit
Operation Manual
Loop Control Board
Operation Manual
P
Loop Control Unit
Function Block Reference
Manual
Loop Control Board
Function Block Reference
P
Manual
Cat. No.
W418 (this manual) Installation and operation procedure for
Face Plate Auto-Builder for NS.
W372 Installation and operation procedures
for the CX-Process Tool.
W463 Provides an outline of the CX-One FA
Integrated Tool Package and the instal-
lation procedure. Refer to this manual
when installing software contained in
the CX-One FA Integrated Tool Pack-
age.
W373 Installation and operation procedures
for the CX-Process Monitor.
W428 Installation and operation procedures
for the CX-Process Monitor Plus.
W374 Installation and operation procedures
for the Loop Control Unit (except for
function blocks).
W406 Installation and operation procedures
for the Loop Control Boards (except for
function blocks).
W375 Detailed information on function blocks
for Loop Control Units.
W407 Detailed information on function blocks
for Loop Control Boards
Contents
ix