Omron CXONE-ALC-V4 - 10-2010 Operation Manual page 139

Segment Program 3 (Block Model 158)
31-40: Displays steps 31 to 40
41-50: Displays steps 41 to 50
51-60: Displays steps 51 to 60
61-70: Displays steps 61 to 70
71-80: Displays steps 71 to 80
81-90: Displays steps 81 to 90
91-100:Displays steps 91 to 100
6: Step Data Display and Setting Buttons
These buttons are used to display and set step data.
Default: B0 Value and the Output Value, Time Width, Unit, Bank No., Wait
Width, and Wait Time, are displayed, and can be set, for each step.
Note Carefully consider the effects that changes will have on equipment before
writing any settings.
■ Bank Data Setting Screen
1
5
6
1: Read Button
This button reads the bank data from the Loop Control Board/Unit. The num-
ber of banks displayed on the screen indicate the range of banks that can be
read. Any settings made on the screen will be discarded if the Read Button is
clicked before clicking the Write Button.
2: Write Button
This button writes the bank data settings to the Loop Control Board/Unit. The
number of banks displayed on the screen indicate the range of banks that can
be written.
3
2
Section 6-19
4
123