Ratio Setting (Block Model 033); Face Plates - Omron CXONE-ALC-V4 - 10-2010 Operation Manual

Ratio Setting (Block Model 033)

6-9

Ratio Setting (Block Model 033)

6-9-1

Face Plates

3: Parameters
The Indication and Setting Block does not provide parameter settings.
4: Realtime trend
The Indication and Setting Block displays a graph for PV only.
The following screen is a Tuning Screen for an Indication and Setting face
plate built using the Face Plate Auto-Builder for NS in a 640×480 screen reso-
lution.
The display and operation of each object in the face plate is the same as the
version for 800×600 screen resolution.
This section describes only the differences between the Ratio Setting Block
and Basic PID Block (Block Model 011). For details on the areas not covered
here, refer to 6-1 Basic PID (Block Model 011).
The Ratio Setting Block is used to set the ratio and bias and has PV-indicating
and ratio-setting functions.
1
2
3
1: Alarm Status Display
Unlike the Basic PID Block, this block does not output any of the high/low PV
alarms or the MV output's deviation alarm.
Section 6-9
73