Connecting To A Screw Terminal Block - Omron CRT1 - 10-2009 Operation Manual

Connecting External I/O for Slave Units
Analog I/O Slave With 2-tier Terminal Block
Units
With e-CON Connectors
With MIL Connectors
Temperature Input Units
Expansion Units
Bit Slaves With e-CON Connectors
With Screw-less Clamp Termi-
nal Blocks
Bit Slave Units with Compact Connec-
tors
3-6-1

Connecting to a Screw Terminal Block

Note
Name
IP54
IP54
For Slave Units with screw terminal blocks, attach the following M3 crimp ter-
minals to signal lines and then connect them to the terminal block.
Tighten the terminal block screws to a torque of 0.5 N·m.
6.0 mm max.
Mounting and Removing Terminal Blocks
When attaching a terminal block to a Slave Unit with two or three terminal
blocks, tighten the mounting screws alternately a little at a time. When remov-
ing a terminal block, loosen the mounting screws alternately a little at a time. If
you tighten or loosen only one of the screws all the way without tightening or
loosening the other screw, the terminal block will warp, possibly causing it to
crack.
Model
CRT1-AD04
CRT1-DA02
CRT1-VAD04S
CRT1-VDA02S
CRT1-VAD04ML
CRT1-VDA02ML
CRT1-TS04T
CRT1-TS04P
XWT-ID08(-1)
XWT-OD08(-1)
XWT-ID16(-1)
XWT-OD16(-1)
CRT1B-ID02S(-1)
CRT1B-OD02S(-1)
CRT1B-ID02SP(-1)
CRT1B-OD02SP(-1)
CRT1B-ID04SP(-1)
CRT1B-MD04SLP(-1)
CRT1B-ID02JS(-1)
CRT1B-OD02JS(-1)
CRT1B-MD02JS(-1)
CRT1B-ID04JS(-1)
CRT1B-OD04JS(-1)
CRT1B-MD04JS(-1)
6.0 mm max.
Section 3-6
I/O connection method
Screw terminal block
(M3)
e-CON connector
MIL connector
Screw terminal block
(M3)
e-CON connector
Screw-less clamp termi-
nal block
XA-series Connector
from J.S.T. Mfg
101