Output Specification; Relay Output - Omron 3G3MV System Configuration Manual

Output Specification

Relay output

Item
Maximum switching capacity
Minimum switching load
Service life of relay
ON delay
OFF delay
Circuit configuration
Note: The service life of relay output contacts shown in the table assumes the worst conditions. The following graph shows the results of OMRON's
service life tests at a switching rate of 1,800 times/hour.
4
Life (x 10 )
300
200
100
50
30
20
10
5
3
2
0.1 0.2 0.3
Transistor outputs (sinking/NPN)
Item
Maximum switching capacity
Minimum switching capacity
Maximum inrush current
Leakage current
Residual voltage
ON response time
OFF response time
Fuse
Circuit configuration
Note: When using OUT01000 or OUT01001 as a pulse output, connect
a dummy resistor as required to bring the load current between
0.01 and 0.1 A. If the load current is below 0.1 A, the ON-to-OFF
response time will be longer and high-speed pulses (source-type
transistor outputs) will not be output. If the load current is above
0.1 A, the transistor will generate more heat and components
may be damaged.
V7 inverter PLC
Specification
2 A, 250 VAC (cos =1)
2A, 24VDC
10 mA, 5 VDC
Electrical:
Mechanical:
15 ms max.
15 ms max.
Internal
circuits
120 VAC, resistive load
24 VDC, = 7 ms
120 VAC, cos = 0.4
240 VAC, cos = 0.4
24 VDC/240 VAC, resistive load
0.5 0.7 1 2 3 5
Contact current (A)
Specification
4.5 to 30 VDC, 0.2 A/ output
0.5 mA
0.9 A for 10 ms
0.1 mA
1.5 V max.
20 µs max.
40 µs max. for 4.5 to 26.4 VDC, 10 to 100 mA
0.1 ms max for 4.5 to 30 VDC, 10 to 200 mA
One fuse per output (cannot be replaced by user)
Output LED
Internal
circuits
150,000 operations (24 VDC resistive load)
100,000 operations (240 VAC inductive load cos =0.4)
20,000,000 operations
Output LED
OUT
OUT
COM
Switching rate: 1,800 times/hour
OUT
OUT 24 VDC
COM (-)
!Caution
Do not apply voltage in excess of the maximum switching capacity
to an output terminal. It may result in damage to the product or fire
Maximum
250 VAC: 2 A
24 VDC: 2 A
381