Testing The Consoles' Built-In Loudspeakers; Testing The Consoles' Microphones; Activating/Deactivating The Flashing Of The Signal Light Ring - Sennheiser SDC 8200 AO System Manual

Configuring the SDC 8200 system
Options
1 Test Tone
Options
2 Test Units
Options
3 Light Ring
92

Testing the consoles' built-in loudspeakers

Test Tone
Via the " " menu item, you can check if the consoles are con-
nected correctly and if the consoles' built-in loudspeakers are working cor-
rectly.
To activate the test tone:
From the central unit's operating menu, choose "
Options Test Tone
" " and "
Status = ON
Choose "
All loudspeakers produce the test tone.
To change the volume of the test tone, choose "
between " High " and "
To change the volume of the test tone, choose "
High
choose between "
To deactivate the test tone, choose "
ENTER key.
The test tone is deactivated.

Testing the consoles' microphones

Test Units
Via the " " menu item, you can check if the consoles' micro-
phones are working correctly
To activate the microphones:
From the central unit's operating menu, choose "
" Options " and " Test Units
Status = ON
Choose "
All microphones are activated one after the other in the order in which
the consoles were initialized. The red signal light ring of the currently
active microphone lights up. After all microphones have been activated
once, activation re-starts with the first microphone.

Activating/deactivating the flashing of the signal light ring

If – in "With Request" or
the microphone key
the green "Request to speak" LED
To activate the flashing of the signal light ring on all consoles:
From the central unit's operating menu, choose "
Options Light Ring
" " and "
Blink in Request
Choose "
If a particpant makes a request to speak, the red signal light ring and
the green "Request to speak" LED
To deactivate the flashing of the signal light ring on all consoles:
OFF
Choose " ".
If a particpant makes a request to speak, only the green "Request to
speak" LED on his console starts flashing.
" one after the other.
".
Low ".
Low
" and " ".
Status = OFF
" one after the other.
".
"With Req. No Clear" mode – a participant presses
on his console, he makes a request to speak and
starts flashing.
" one after the other.
" and press the ENTER key.
on his console start flashing.
Conference
",
Level
". You can choose
Frequency
". You can
" and press the
Conference
",
Conference
",