Muting The Microphone Of The Interpreter Console; Displaying Text Messages On The Interpreter Console's Display; Operating The Central Unit; Adjusting The Volume Of The Consoles' Built-In Loudspeakers - Sennheiser SDC 8200 AO System Manual

Operating the components of the SDC 8200 system
40

Muting the microphone of the interpreter console

To mute your microphone:
Press the MUTE key
Your microphone is muted.
To turn on your microphone again:
Release the MUTE key
Your mirophone is turned on again.

Displaying text messages on the interpreter console's display

If a PC with software control is connected to the central unit, you can
receive text messages from the central unit.
If you have received a text message, the MESSAGE LED on your interpreter
console lights up.
Press the MESSAGE key
The text message is shown on the display.
Press the MESSAGE key
The display returns to the standard display.

Operating the central unit

Before a conference starts, you have to configure your entire conference
and interpretation system via the central unit's operating menu (see "Con-
figuring the SDC 8200 system" on page 60); it is, however, possible to
make changes to individual settings during a conference.

Adjusting the volume of the consoles' built-in loudspeakers

Adjust the volume of the consoles' built-in loudspeakers so that all partic-
ipants can clearly hear all audio information:
Turn the jog wheel
The volume of the consoles' built-in loudspeaker is increased or
reduced. The bars on the start display indicate the set volume level.
Note!
The conference participants cannot adjust the volume of their consoles'
built-in loudspeakers! However, each participant can individually
adjust the headphone volume on his or her console.
The interpreters can individually adjust both the volume of their consoles'
built-in loudspeakers and the volume of the connected headphones.

Restarting the conference and interpretation system

The front panel of the central unit features a reset button which allows you
to restart the central unit.
Insert a pointed tool into the small hole
central unit.
The central unit restarts with the last settings configured.
and keep it pressed.
.
.
again.
on the central unit.
on the front panel of the