Putting The S1 Digital Into Operation; Connecting The Headset To The Intercom; Powering The Headset - Sennheiser S1 DIGITAL Instruction Manual

Putting the S1 DIGITAL into operation

Putting the S1 DIGITAL into operation

Connecting the headset to the intercom

M
Jack plug of the control unit
5.25 mm jack plug
¼" (6.35 mm) jack plug

Powering the headset

CAUTION
Danger of short circuit!
Technical defects can cause a short circuit.
Before putting the headset into operation, ensure that the socket of the on-
board DC power supply system is protected by a 1 A fuse.
There are different options for powering the headset:
• Connection to the on-board DC power supply system (12 – 35 V
a mounted 3-pole XLR socket or the cigarette lighter socket
• Power supply via two batteries/rechargeable batteries inserted in the control
unit (to be ordered separately)
Connection via a 3-pole XLR socket
The Adapter-P-XLR-3
Sennheiser partner) allows you to connect the headset to the on-board DC power
supply system (12 – 35 V
8 | S1 DIGITAL
L
L
M
adapter cable (optional accessory available from your
) via a mounted 3-pole XLR socket.
DC
Have a 3-pole XLR socket (optional accessory)
mounted by a technician qualified to perform this
type of installation.
Connect the
mounted 3-pole XLR socket.
Connect the hollow jack plug of the adapter cable
to the hollow jack socket on the control unit.
Connect the jack plugs of the control unit
to the corresponding jack sockets of your
intercom.
Jack socket of the intercoms
Microphone input
Headphone output
Adapter-P-XLR-3
) via
DC
adapter cable to the