Using the S1 DIGITAL
Switching the headset on/off
Set the Power
OFF/ON
ON
NoiseGard
the battery charge status or power supply via the on-board DC power
supply system.
OFF
NoiseGard
When the S1 DIGITAL, and thus NoiseGard
be used as a conventional, passive headset.
Switching the Bluetooth function on/off
Switch the headset on to use the Bluetooth function.
Switching the Bluetooth function on
When switching the Bluetooth function on for the first time, the headset will
automatically go into pairing mode.
When the headset is already paired with a Bluetooth device, the Bluetooth con-
nection is automatically established. You hear a beep in the headset.
When the headset is already paired with a Bluetooth device but the Bluetooth
device is switched off or out of range, the
for 3 minutes to connect to one of the up to 8 previously paired Bluetooth
devices. If this fails, the Bluetooth function automatically switches off after
10 minutes.
switch to the position ON.
TM
/digital is switched on. The Power LED lights up, indicating
TM
/digital is switched off. The Power LED goes off.
OFF
Press and hold the multi-function button
LED flashes blue. You hear an ascending beep.
ON
TM
/digital, is switched off, it can
LED flashes blue. The headset will try
until the
S1 DIGITAL
| 17