Sennheiser S1 DIGITAL Instruction Manual page 10

Putting the S1 DIGITAL into operation
Connection via the cigarette lighter socket
The Adapter-P-CIG
Sennheiser partner) allows you to connect the headset to the on-board DC power
supply system (12 – 35 V
Power supply via two batteries/rechargeable batteries
1 Open the cover of the battery compartment on the control unit.
2 Insert two AA size batteries/rechargeable batteries. Observe correct polarity.
3 Close the cover of the battery compartment.
1
When you switch the headset on (see page 19), the Power LED
mation on the remaining battery/rechargeable battery capacity.
LED lights up yellow:
LED lights up red:
adapter cable (optional accessory available from your
) via the cigarette lighter socket.
DC
Connect the cigarette lighter plug to the on-board
DC power supply system.
Connect the hollow jack plug of the adapter cable
to the hollow jack socket on the control unit.
Where required, connect an additional device to
the XLR-3 socket of the adapter cable (max. 1 A).
The battery/rechargeable battery capacity is sufficient.
The batteries/rechargeable batteries are flat.
2
H
provides infor-
S1 DIGITAL | 9