Table of Contents
Advertisement
Putting the S1 DIGITAL into operation
Pairing the headset with a Bluetooth device
The following chapter describes, by way of example of a mobile phone, how to
pair the headset with a Bluetooth device.
Make sure that
– the headset is connected to the on-board DC power supply system or that
the control unit is equipped with fully charged batteries/rechargeable
batteries,
– the mobile phone's Bluetooth visibility is enabled (see the instruction
manual of the corresponding Bluetooth device),
– the headset is placed close to the mobile phone (approx. 50 cm or 19.7").
Switch the headset on by setting the Power
ON.
On your audio source, activate the Bluetooth function "Add a new device".
When the mobile phone prompts for a password or PIN code, enter the default
PIN code "0000".
Proceed as described in the instruction manual of the mobile phone.
Once the headset has found the mobile phone, the devices exchange
device identification information. The
You hear an ascending beep. The devices have identified each other
and the headset is paired with the mobile phone.
If no device is found within approx. 5 minutes, the
3 times red and you hear a descending beep. The headset will then
try for 3 minutes to connect to one of the up to 8 previously paired
Bluetooth devices. If this fails, the Bluetooth function automatically
switches off after 10 minutes.
In this case, repeat the necessary steps to pair the headset with the mobile
phone again.
Press and hold the multi-function button
LED alternately flashes blue and red.
G
OFF/ON
switch
to the position
LED flashes 3 times blue.
S1 DIGITAL
until the
LED flashes
| 13
Hide quick links:
Advertisement
Table of Contents
