Table of Contents
Advertisement
1-2. TEMPORARILY SETTING UP AND CONNECTING CP-1 PWB ASSEMBLY
The following is an example of how to place and connect the main board without a jig, when repairing the CP-1 PWB
assembly.
1.
Place the mechanism unit and main board up side down
2.
Operate the unit using the buttons on TM-1 PWB or the
as a whole on a flat surface with the foil side of the main
remote control.
board facing up.
CP-1 PWB Assembly (Foil side)
Terminal Boord
Screws
TM-2 PWB
Cassette Compartment
Mechanism Main Unit
Fig. 1-1-4
1-3. INSTALLATION OF THE FRONT PANEL
When installing the front panel to the chassis after repaires and adjustments.
2.
Set the cassette door to half-opened state as shown in
Fig.1-1-5, and install the front panel to the chassis.
Jutted part of
Cassette Holder
Front Panel
Door Opener Lever
Cassette Door
(Position B)
Cassette Door
(Position A)
2-3E
Advertisement
Table of Contents
