Table of Contents
Advertisement
3-10.
LGUIDE LEVER ASSEMBLY AND
1)
2)
3)
4)
LOAD LEVER ASSEMBLY
(See Figs.3-10-1)
Refer to section 3-3 and remove the cassette mechanism
assembly.
Refer to sections 3-9-1 and 3-9-2 ,then remove the pinch
roller lever assembly and the opener mounting.
After removing the washer @, remove
the L guide
act lever assembly ©).
Remove the special nut®, then remove
the load lever
assembly @ and the L guide lever spring ®.
ASSEMBLY NOTES:
1)
2)
3)
4)
Fig. A
®Special nut
@Load lever
xX
ON
assembly |
\
ae
<4
5
@L guide lever spring
®L guide
Apply grease SGL-505 to the toothed area® of the
L guide act lever assembly © and around the shafts
@) and G0.
Refer to section 4-3 and adjust the height of the load
lever assembly.
Hook the L guide lever spring® into the stopper @
and load lever assembly @ shown in Fig. A.
Put the pin @ of the L guide act lever assembly into
the cam groove @ of the crescent slide.
®L guide lever spring
@Load lever assembly
@Washer
act lever
assembly
Fig.3-10-1
5-17
3-
1)
2)
3)
4)
5)
11.BT LEVER ASSEMBLY (See Fig.3-11-1)
Refer to section 3-2 and remove the mechanism unit.
Refer
to section
3-3-1
and
remove
the
cassette
mechanism assembly.
Remove the BT spring @.
Remove
the clamp@® on the underside
of the
mechanism
chassis,
then
remove
the
BT
lever
assembly @).
Remove the clamp © on the band brake assembly @.
Then, as shown in Fig. A, align the other end of the
band brake assembly with the protruding parts of the
BT lever assembly @) before removing it.
ASSEMBLY NOTES:
1.
When fitting the BT lever assembly @), be careful not to
bend
the
stopper® or
the
S incline
mounting
assembly @ out of shape by knocking it against them.
2.
Hook the long hook of the BT spring) into the BT lever
assembly @), as shown in Fig. B.
3.
After assembly,
make
sure that the mountings
on
both
ends
of
the
band
brake
assembly@
are
positioned as shown in Fig. C.
4.
After assembly,
refer to section 4-2-1, and make the
appropriate adjustment.
@®Clamp
Fig. A
@Band brake
ER
assembly
@BT lever
assembly
~
ace
Protruding
_ .
.
parts
Fig. B
@S incline
mounting
assembly
o>
@Stopper
——
Fig.3-11-1
Advertisement
Table of Contents
