Installation Of The Front Panel - Sony SLV-E120AE Service Manual

1-2. TEMPORARILY SETTING UP AND CONNECTING CP-1 PWB ASSEMBLY
The following is an example of how to place and connect the main board without a jig, when repairing the CP-1 PWB
assembly.
1. Place the mechanism unit and main board up side down
as a whole on a flat surface with the foil side of the main
board facing up.
Screws
Mechanism Main Unit
TM-1 PWB
Cassette Compartment

1-3. INSTALLATION OF THE FRONT PANEL

When installing the front panel to the chassis after repaires and adjustments.
1.Pressing down the door opener lever of the mechanism
main unit.
2. Set the cassette door to half-opened state as shown in
Fig. 1-1-5, and install the front panel to the chassis.
Jutted part of
Cassette Holder
Front Panel
Cassette Door
(Position A)
CP-1 PWB Assembly (Foil side)
9
2. Operate the unit using the buttons on TM-1 PWB or the
remote control.
TM-2 PWB
Note:
Opened cassette door position does not install the
front panel to the chassis.
Door Opener Lever
Cassette Door
(Position B)
2-3 E
Terminal Board
Fig. 1-1-4
Fig. 1-1-5