Table of Contents
Advertisement
3-5-4. CYLINDER ASSEMBLY
(See Fig.3-5-7)
1)
Refer to sections
3-5-2
and. 3-5-3,
and
remove
the
cylinder unit, the rotor, and the stator.
Screws
ae
2)
Remove
the
three
screws@
and
the cylinder
assembly @).
ASSEMBLY NOTES:
1.
Becareful not to scratch or soil the top of the cylinder.
After fitting the cylinder, clean the surface.
2.
Align the cylinder assembly@ with the two dowels @
on the cylinder mounting @).
3.
After fitting the cylinder assembly,
do the tape path
adjustment
as instructed
in section
4-3 and do the
switching position adjustment of the servo circuit.
@ Audio R/P head assembly
' (ACE head)
@Hole
Fig.3-6-1
3-6-2. FULL ERASE HEAD (See Fig.3-6-2)
1)
Unplug the connector from the full erase head (1).
2)
Remove the screw @® and the full erase head @.
ASSEMBLY
NOTE:
1.
After assembly, clean the full erase head @.
@ Dowels
mounting
Fig.3-5-7
@Full erase head —»
3-6. FE HEAD AND ACE HEAD
|
3-6-1. AUDIO R/P HEAD ASSEMBLY (ACE HEAD)
(See Fig.3-6-1)
1)
Unplug
the connector
from
the audio
R/P head
assembly (ACE head).
2)
Remove
the two
screws(@)
and the audio
R/P head
assembly (ACE head) @.
ASSEMBLY
NOTES:
1.
Align the hole@ on the audio R/P head assembly
(ACE head) with the pin@ on the chassis unit.
A
2.
After assembly, check that the clamp © on the cleaner
roller assembly
has snapped
into the mounting
of
the audio R/P head assembly (ACE head) @.
3.
After assembly, clean the surface of the head with a
Fig.3-6-2
soft cloth or chamois.
4.
After assembly,
refer to section
4-3, and adjust the
head height, the azimuth and the tracking (X) position.
Advertisement
Table of Contents
