Test Equipment And Standards Required - Sony SLV-E105 Service Manual

2. ELECTRICAL ADJUSTMENT
2-1. SERVO CIRCUIT ADJUSTMENT
These adjustments should be done upon completion of the tape transport adjustments.
« — If the tape transport adjustments (except the tilt adjustment) are done after these adjustments, follow the procedures again
in section 2-1-3, "switching position adj."
* When acassette tape is loaded, auto-tracking will be set immediately after starting the first playback. To adjust servo circuit,
set back to the manual tracking condition, and set the tracking to the center position.
2-1-1. TEST EQUIPMENT AND STANDARDS REQUIRED
Vertical sensitivity :5 mV/DIV, external trigger
Bandwidth > more than 10 MHz
MH-2 (H-7099-052-H) : SP mode, monoscope, 6 KHz
VHS-type cassette tape
@TP103 3in1 Tuner——>!
CN351 TP AOI) SE
C1047(COLD) {7}? TP202C)-"
. Pro i
4
37
1101
CN303 ,' P
saie9 ©
©
CP-1 PWB (Foil side)