Table of Contents
Advertisement
3-9-2. PINCH LIFT CAM AND PINCH CAM GEAR
(See Figs.3-9-2 and 3-£ 3)
1)
Refer to section 3-2 and remove the mechanism unit.
When
you do this, make sure the mechanism
its in
EJECT mode.
2)
Refer to section
3-9-1
and
remove
the pinch
roller
lever assembly.
3) After removing the screw, undo
the three clamps@),
then remove the opener mounting @.
4)
Remove the clamp @ and the pinch lift cam ©.
5)
Remove the pinch cam gear ©.
ASSEMBLY
NOTES:
1.
Apply grease SGL-505
around the shaft @, all over
the teeth® of the pinch cam gear ©, all over the
teeth of the pinch lift cam ©, all over the cam grooves
@), and all over the "V Part©" of the opener mounting
@ . Apply grease EM-L30LG
to the outside of the
shaft ® and all over the top cam © of the pinch cam
gear ©).
2.
Check that the positioning
mark@ on the mode
switch @®) is aligned with the arrow@) onthe MC-1 PWB
assembly,
as
shown
in Fig.3-9-3.
Then
align
the
triangular mark @ on the pinch cam gear © with the
arrow @ on the MC-1
PWB
assembly.
After that,
align the round hole @ on the pinch lift cam © with
the indentation @ on the pinch cam gear ©.
If you have carried out the above alignments and the
pinch roller will still not move up and down or perform
the
pressing
movement
correctly,
refer to section
3-15 and check the alignment
of the gear wheels
1
and 2, the main cam, and the mode switch.
a
@Screw
©"V" part
@ Opener
mounting
©)Pinch lift cam
@Clamps
@
©Pinch
cam gear
@ Arrow on MC-1 PWB
ad
assembly
ae a @Positioning
marks
on mode switch
®pPinch lift cam
Indentatio
@ Arrow —+
5.
ras
<. Ar
@Triangular mark
\ @Round hole
Fig.3-9-3
Advertisement
Table of Contents
