Table of Contents
Advertisement
Replacing the internal light bulb
Power voltage
Danger of electrocution
• Unplug the appliance.
• Wear protective gloves.
1. Completely remove all accessories from
inside the oven.
2. Remove the rack/tray support frames.
3. Use a tool (e.g. a spoon) to remove the bulb
cover.
Take care not to scratch the enamel of
the oven cavity wall.
INSTALLATION
The appliance must be installed by a
qualified technician and according to
the regulations in force.
Appliance factory set for gas: NG
pressure 1kPa.
Positioning
See General safety instructions.
Depending on the type of installation, this
appliance belongs to classes:
Class 1
Class 2 - subclass 1
22 - INSTALLATION
Free-standing
Built-in
4. Slide out and remove the light bulb.
Do not touch the halogen light bulb
directly with your fingers, use an
insulating material.
5. Replace the light bulb with one of the same
type (40 W).
6. Refit the cover. Ensure the moulded part of
the glass (A) is facing the door.
7. Press the cover completely down so that it
attaches perfectly to the bulb support.
The appliance can be placed against walls that
are higher than the work surface, at a minimum
distance of X mm from the side of the appliance.
Any wall units installed above the appliance's
worktop must be positioned at least Y mm from
it.
X
Y
150 mm
750 mm
91477A388/A
Advertisement
Table of Contents
