Table of Contents
Advertisement
9
OTHER FUNCTIONS
■ Navigation
The transceiver assists you to navigate to a selected destination.
L The function works only when the transceiver is receiving valid GPS signals.
L The function cannot work while in the MOB mode.
NOTE: The Navigation function is a supplemental aid to navigation only, and is not
intended to be a substitute for primary navigation equipment.
D Starting navigation
There are 3 ways of setting a destination using
selecting in the Waypoint list.
NOTE: A popup screen is displayed when the vessel arrives at or near the destination.
To stop the function, push any key.
L When the Audible Alarm function is set to "ON," an alarm also sounds. (p. 60)
Using [NAV]:
NAV
1.
Push
• The "Waypoint" screen is displayed.
2.
Push [▲] or [▼], or rotate [CH/ENT] to select a
waypoint.
3.
Push
Start
• The plotter screen is displayed, and the transceiver
starts to navigate.
•
is displayed on the plotter screen.
4.
Push the Software Key for your next operation.
Selecting in the AIS list:
1.
Open the list screen.
[MENU] > AIS > Target/Danger/Friends list
2.
Push [▲] or [▼] or rotate [CH/ENT] to select an AIS target.
3.
Push
NAV
• "Start navigation. Are you sure?" is displayed.
4.
Push
OK
• The plotter screen is displayed, and the transceiver starts to navigate.
•
is displayed on the plotter screen.
TIP: You can also start navigation in the details on the AIS target.
1.
Repeat steps 1 and 2.
2.
Push
Details
• The "Details" screen is displayed.
3.
Repeat steps 3 and 4.
67
on the operating screen.
to start navigation.
.
to start navigation.
, [ENT], or [►].
NAV
, selecting in the AIS list, and
Advertisement
Table of Contents
