Signal Connections; Video Input Channels; Bnc Connector - National Instruments NI PCI-1410 User Manual

Signal Connections

Video Input Channels

BNC Connector

© National Instruments Corporation
Download from Www.Somanuals.com. All Manuals Search And Download.
This chapter describes cable connections for the NI PCI-1410 device.
The video input channels for the NI 1410 support two input
modes—referenced single-ended (RSE) and differential (DIFF). A
channel configured in DIFF mode uses two inputs. One input connects to
the positive terminal, and the other connects to the negative terminal. A
channel configured in RSE mode uses one input, which connects to the
positive terminal. The negative input is internally tied to ground.
The BNC external connector supplies an immediate connection (RSE mode
only) to the NI 1410 VIDEO0 input. To connect a camera to VIDEO0, first
verify that the W1 jumper is in place. Next, use the 2 m BNC cable shipped
with the NI 1410, or another 75 Ω BNC cable, to connect to the BNC
connector. If you are using a BNC connection, the VIDEO0 connection
on the 68-pin VHDCI I/O connector must be left open.
Refer to Figure 3-1 for the location of the NI 1410 W1 jumper and the
connectors discussed in this chapter.
3-1
3
NI PCI-1410 User Manual