Signal Connector Pinout - National Instruments FD-11603 Manual

The following accuracy table is valid for calibration under the following conditions:
• Ambient temperature 23 °C ± 5 °C
• No nodes share power with the FieldDAQ device under calibration
The test limits listed in Table 3 are derived using the values in the following table.
Table 7. FD-11603 Voltage Accuracy Under Calibration Conditions
Percent of Reading (Gain Error)
Note Values in this table are intended for calibration verification only. These
values only apply under the specific calibration conditions described in this
document, and are not to be construed as general operational specifications of the
FD-11603. For operational specifications, refer to the most recent FD-11603
Specifications at ni.com/manuals.

Signal Connector Pinout

Pin Number
1
3
5
2
4
* Wire color pertains to SHM125M I/O cables sold through NI. Other manufacturers' cable
wire colors may vary.
±0.037%
Figure 6. FD-11603 Pinout
NC
NC
AI+
Table 8. Signal Descriptions
Wire Color*
Brown
Blue
Gray
White
Black
Percent of Range (Offset)
AI–
1 2
5
4 3
NC
Signal
NC No connect. Do not connect signals to
this terminal.
AI- Negative analog input voltage signal
AI+ Positive analog input voltage signal
FD-11603 Calibration Procedure | © National Instruments | 9
±1.05 mV
Description