Table of Contents
Advertisement
Cleaning the plinth filter
Clean the plinth filter carefully and
thoroughly under running water.
Tip: To speed up the removal of residue
from the surface, run a water jet vertic-
ally over the front of the plinth filter.
Squeeze the plinth filter very carefully
several times as you rinse it.
Rinse the entire plinth filter thor-
oughly until all visible residue has
been removed.
Continue to carefully squeeze the
plinth filter until all of the water has
been removed.
Tip: To soak up water, place the damp
plinth filter between 2 hand towels. On
an even surface, gently press down on
the fluff filter with the back of your hand.
This will dry the plinth filter more
quickly.
The plinth filter must not be fitted
dripping wet.
Otherwise, this could cause a fault.
Carefully squeeze the water out of
the plinth filter.
Cleaning and care
If a drying programme is interrupted
with a fault message after the clean
plinth filter has been refitted, the plinth
filter was too wet when it was refitted.
Carefully squeeze the water out of the
plinth filter again. Leave the plinth filter
to air-dry.
If a fault occurs again despite this, it
may be due to stubborn residue from
washing substances. Reactivate the
plinth filter in the washing machine.
See "Problem solving guide – Reactiv-
ating the plinth filter".
Damage caused by an insuffi-
ciently cleaned or damaged plinth fil-
ter.
If the plinth filter has not been prop-
erly cleaned or is damaged, the heat
exchanger will be clogged. There will
be an insufficient flow of air and heat
in the heat exchanger. This will re-
quire a visit from the Customer Ser-
vice Department.
Before and after cleaning, check the
plinth filter in accordance with the
description in "Replacing the plinth
filter". The plinth filter must be intact
and in perfect working order after
cleaning.
Use a damp cloth to remove any fluff
from the handle.
47
Advertisement
Table of Contents
