Miele PDR 514 Operating And Installation Instructions
Commercial tumble dryers
Hide thumbs
Also See for PDR 514:
- Quick start manual (156 pages) ,
- Operating and installation instructions (36 pages) ,
- Operating and installation instructions (56 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Miele PDR 514
Summary of Contents for Miele PDR 514
- Page 1 Operating and installation Instructions Commercial Tumble Dryers PDR 514/518/522/528/544 To avoid the risk of accidents or damage to the en-AU, NZ appliance, it is essential to read these instructions before it is installed and used for the first time. M.-Nr. 11 865 310...
-
Page 2: Table Of Contents
Contents Caring for the environment .................... Warning and Safety instructions ................... Correct application......................Preventing problems ......................Technical safety......................... Gas-heated tumble dryers .................... Correct use........................10 Accessories ........................10 Operating the tumble dryer .................... 12 Machines with residual moisture control (ROP) ..............12 Drying levels ........................ - Page 3 Contents Installation........................30 Installation requirements ....................30 General operating conditions .................... 30 Transport ........................... 30 Installing the tumble dryer....................30 Anchoring .......................... 32 Electrical connection ......................32 Supply air/Exhaust air ....................... 33 Steam connection (only for steam-heated variants)............33 Hot water connection (only for hot water-heated variants) ..........33 Gas connection (only for gas-heated variants)..............
-
Page 4: Caring For The Environment
Please dispose of it at your local community waste collection / recycling centre for electrical and electronic appliances. Consult with Miele if necessary. Please ensure that your old appliance presents no danger to children while being stored awaiting disposal. -
Page 5: Warning And Safety Instructions
“Installation”, as well as in the “Warning and Safety instructions”. Miele cannot be held liable for injury or damage caused by non-compliance with these instructions. Keep these operating instructions in a safe place and pass them on to any future owner. -
Page 6: Preventing Problems
This tumble dryer may also be operated in public areas. Uses other than those listed above are incorrect and shall release the manufacturer from liability. Preventing problems Do not make any alterations to the dryer, unless authorised to do so by Miele. -
Page 7: Technical Safety
The tumble dryer may only be operated with a peak- load device if this is connected to the tumble dryer via the Miele connector box and the relevant settings have been configured on the tumble dryer. There is a risk of the laundry self-igniting if the drying programme is cancelled before the cooling phase has finished. - Page 8 Unauthorised repairs could result in unforeseen dangers for the user, for which Miele cannot accept liability. Repairs must only be carried out by a Miele authorised service technician, otherwise any subsequent damage will not be covered by the warranty.
-
Page 9: Gas-Heated Tumble Dryers
If the electrical connection cable is faulty, it must only be replaced by a Miele authorised service technician to protect the user from danger. Gas-heated tumble dryers ... -
Page 10: Correct Use
Do not store open containers of these agents near the appliance. Accessories Only use genuine Miele spare parts and accessories with this machine. Using spare parts or accessories from other manufacturers will invalidate the warranty, and Miele cannot accept liability. - Page 11 Warning and Safety instructions Miele cannot be held liable for damage caused by non-compliance with these Warning and Safety instructions.
-
Page 12: Operating The Tumble Dryer
The programme can be started when the sensor is flashing on and off. The sensor lights up constantly once the programme has started. Optical interface Used for data transfer by Miele Professional Service. Programme selector For selecting programmes and for switching the machine off. The tumble dryer is switched on when you select a programme and switched off by turning the programme selector to the position. -
Page 13: Drying Programmes
Operating the tumble dryer Drying programmes - position = “Cottons” programme For drying cotton and linen . - position = “Cottons Low temperature” programme For drying delicate cotton and linen fabrics. - position = “Synthetics/Delicates” programme For drying synthetic fibres and artificial silk to 20% residual moisture. - ... -
Page 14: Machines With Time Control (Top)
The programme can be started when the sensor is flashing on and off. The sensor lights up constantly once the programme has started. Optical interface Used for data transfer by Miele Professional Service. Time selector For selecting times and for switching the machine off. The tumble dryer is switched on when you select a time and switched off based on the position of the time selector . - Page 15 Operating the tumble dryer - 60 position = Timed programme 60 minutes - position = Machine off...
-
Page 16: Machines With Payment Systems (Cop)
The programme can be started when the sensor is flashing on and off. The sensor lights up constantly once the programme has started. Optical interface Used for data transfer by Miele Professional Service. Temperature setting selector For selecting temperature settings and for switching the machine off. The tumble dryer is switched on when you select a temperature setting and switched off based on the position of the temperature setting selector . - Page 17 Operating the tumble dryer For drying cotton and linen fabrics. - position = Machine off...
-
Page 18: How The Control Panel Works
Operating the tumble dryer How the control panel works The sensors react to fingertip contact. Selection is possible as long as the respective sensor is illuminated. If a sensor is brightly lit, this means it is currently selected. If a sensor is dimly lit, this means it can be selected. Sensors for the drying levels After selecting a drying level programme with the programme selector, the recommended drying level lights up. -
Page 19: Using For The First Time
Complete the initial commissioning process. During the initial commissioning process, you will need to define the settings for daily use of the tumble dryer. Some settings can only be modified during the initial commissioning process. After that, they can only be changed by Miele Professional Service. -
Page 20: Drying
Drying 1. Notes on correct laundry care Washing Heavily soiled laundry must be washed particularly thoroughly. Use sufficient detergent and select a high wash temperature. If in doubt, wash the items several times. New, coloured items should be washed thoroughly and separately. Do not dry these garments together with light coloured garments. -
Page 21: Selecting A Programme
Drying Open the door. Load the laundry. Do not overload the drum. Overloading can cause unnecessary wear and tear to the laundry and give a disappointing drying result. It can also cause more creasing. Closing the door Damage caused by laundry getting trapped. Laundry can be damaged by getting trapped when closing the door. -
Page 22: Selecting Delay Start
Drying Timed drying programmes and other programmes Warm air You can set the duration in one-minute increments from minutes to hours. Touch the or sensor repeatedly until the required programme duration appears in the time display. The drying level is preset by the dryer and cannot be altered. -
Page 23: Starting A Programme
Drying - The drum will rotate briefly every hour until the start of the programme to reduce laundry creasing (Anti-crease function). 4. Starting a programme Starting a Touch the flashing Start/Stop sensor. programme The Start/Stop sensor lights up. Programme sequence - If Delay Start has been selected, the Delay Start period will start to count down first. -
Page 24: Removing The Laundry
Drying The tumble dryer will switch off automatically after the programmed time after the end of a programme. Removing the laundry Open the door. Remove all of the laundry from the drum. Damage caused by overdrying. Laundry left in the dryer can be damaged by overdrying. Always remove all items from the drum once drying has finished. -
Page 25: Changing The Programme Sequence
Changing the programme sequence Changing a programme after it has started You cannot change to another programme once a programme has started (this prevents unintentional alterations). You will need to cancel the current programme before you can select a new one. ... - Page 26 Changing the programme sequence Remaining programme time Altering the programme sequence can cause the programme duration shown in the display to “jump”.
-
Page 27: Cleaning And Care
Cleaning and care Cleaning the fluff filter Risk of fire if the tumble dryer is operated without a fluff filter. If there is no fluff filter, the air channels, heating elements and ducting can become clogged during drying and may catch fire. The fluff filter must not be removed for cleaning. -
Page 28: Cleaning The Drum And The Outside Of The Casing
In the case of electrically heated tumble dryers, the heater bank and the heating shaft must also be checked by the Miele Professional Service Department. In the case of gas-heated dryers, the burner and the burner area must be checked. -
Page 29: After Sales Service
After sales service Optional accessories Optional accessories for this tumble dryer are available from Miele (see contact details at the back of these instructions). Contact in case of fault In the event of any faults which you cannot remedy yourself, please contact Miele Professional Service. -
Page 30: Installation
Installation Installation requirements The tumble dryer must only be installed and commissioned by the Miele Professional Service Department or an authorised technician. The tumble dryer must be installed in accordance with all relevant regulations and standards. The dryer must only be operated in a room that has sufficient ventilation and which is frost-free. - Page 31 Installation PDR 514/518/522/914/918/922 PDR 528/544/928/944 1,400 mm 1,640 mm 906 mm 1,206 mm PDR 514/914: 852 mm PDR 528/928: 1,018 mm PDR 518/918: 1,035 mm PDR 544/944: 1,384 mm PDR 522/922: 1,164 mm To facilitate any future maintenance work, a maintenance corridor with a width of at least 500 mm must be set up behind the machine and must be accessible at all times. The distance between the machine and any walls must not fall below the specified minimum values.
-
Page 32: Anchoring
If more than one voltage is specified on the data plate, the tumble dryer can be converted for connection to the relevant input voltage. This conversion must be performed by the Miele Professional Service Department or by an authorised technician. During the conversion, the wiring instructions given on the wiring diagram must be followed. -
Page 33: Supply Air/Exhaust Air
The gas heating is configured at the factory in line with the gas specifications on the sticker on the rear of the appliance. If the gas type is changed, a conversion kit must be requested from the Miele Professional Service Department (please specify the appliance type, serial number, gas type, gas group, gas connection pressure and country of installation). - Page 34 Installation Risk of electric shock and injury due to using the tumble dryer without the complete casing. If the casing is dismantled, it is possible to come into contact with live or rotating machine parts. Once the tumble dryer has been installed, replace all the casing parts that were removed.
-
Page 35: Optional Accessories
Miele cannot accept liability. XCI box The optional XCI box allows external hardware from Miele and other suppliers to be connected to the Miele Professional machine. External hardware includes, e.g. payment system, peak-load system, pressure sensor or an external vent flap. -
Page 36: Technical Data
Technical data Technical data PDR 514 PDR 518 PDR 522 PDR 528 PDR 544 Height 1400 mm 1400 mm 1400 mm 1640 mm 1640 mm Width 906 mm 906 mm 906 mm 1206 mm 1206 mm Depth 852 mm 1035 mm 1162 mm 1019 mm 1385 mm Depth with door open 1456 mm... - Page 38 Freemans Bay Auckland 1011 New Zealand Telephone: 0800 4 MIELE (0800 464 353) www.miele.com.au/professional sales@miele-professional.com.au Miele Global Headquarters: Miele & Cie. KG Carl-Miele-Straße 29, 33332 Gütersloh, Germany Alteration rights reserved / Publication date: 43.21 M.-Nr. 11 865 310 / 00 ...