Table of Contents
Advertisement
Cleaning and care
2. When to clean the filter in the plinth
The filter in the plinth is behind the fluff
filter flap on the bottom left.
With normal use
Clean the filter when this prompt ap-
pears in the display:
and rinse the plinth filter.
With continuous use
Clean once a day and also when the
prompt appears in the display.
The surface of the filter in the filter in-
sert is visible after removing the fluff
filter. This filter surface also has to be
cleaned.
To delete the message: touch the
sensor control.
Damage caused by insufficient
cleaning or by operation with a worn,
damaged filter in the plinth.
There is insufficient flow of air and
heat in the heat exchanger due to
clogging. This requires a visit from
the Service department.
This can be avoided by following the
advice in these operating instruc-
tions.
42
Clean the fluff filter
.
OK
Advertisement
Table of Contents
