Eizo CuratOR LX1910 Instructions For Use Manual page 29

Function
Brightness
Contrast
Auto Brightness/Con-
trast
Auto Position/Clock/
Phase
Clock
Phase
Hor. Position
Ver. Position
Reset ADC
CuratOR LX1910
Instructions for Use, 08/2022
Values Description
-99–99 Set brightness
Adapting the representation of darker picture areas.
-99–99 Set contrast
Adapting the representation of brighter picture areas.
Auto function
Auto functions are used to automatically set the image
parameters of analog signals. When you use the func-
tion, brightness and contrast are automatically set.
Note: The quality of settings depends on the image con-
tent and type of synchronization. We recommend dis-
playing an SMPTE test picture.
Auto function
Auto functions are used to automatically set the image
parameters of analog signals. When you use the func-
tion, the position, phase and clock are automatically set.
Note: The quality of settings depends on the image con-
tent and type of synchronization. We recommend dis-
playing an SMPTE test picture.
Set the input signal clock
If vertical lines easily display blurred, this can be cor-
rected by adjusting the clock.
Note: To correct the clock, we recommend displaying a
vertical line from the "Pixel On/Off" test pattern.
0–63 Set the input signal phase
If vertical lines are slightly blurred, this can be corrected
by adjusting the phase.
Note: To correct the phase, we recommend displaying a
vertical line from the "Pixel On/Off" test pattern.
Shift the picture in the horizontal direction
Note: The setting is optimal when the entire image to be
displayed fills then entire display surface of the monitor,
down to the last pixel (with the identical monitor and
graphics card settings).
Shift the picture in the vertical direction
Note: The setting is optimal when the entire image to be
displayed fills then entire display surface of the monitor,
down to the last pixel (with the identical monitor and
graphics card settings).
Reset analog settings
If you perform this function, the brightness and contrast
values will be reset to the values after the final adjust-
ment.
Operation
7.5 "Geometry" menu
29