Eizo CuratOR LX1910 Instructions For Use Manual page 22

Commissioning
6.4 Adapting the monitor to an analog video source
Adjustment of brightness and contrast
Note
The auto function for adjusting brightness and contrast is only available for analog signals.
The picture quality for digital video signals is already optimized, and adjustment is not re-
quired.
1. Use the SMPTE test pattern for the display.
2. Select the function "Analog Settings" in the "Geometry" menu.
3. In the menu "Geometry > Analog Settings", select the function "Auto brightness/contrast".
4. Start the autofunction with "Yes".
ð The automatic values for brightness and contrast are set. Optimization of brightness and
contrast may be necessary depending on the graphics card.
Therefore, perform the following steps.
Optimizing the values for brightness and contrast
1. Direct the photometer toward the black level (0% field) of the SMPTE test pattern.
2. Change to the "Geometry > Analog Settings" menu in the OSD.
3. Using the "Brightness" function, reduce the brightness value until the measured lumi-
nance no longer falls.
4. Increase the brightness value a little:
ð This is the optimum brightness value.
5. Direct the photometer toward the white level (100% field) of the SMPTE test pattern.
6. Using the "Contrast" function, find the contrast value at which the luminance remains con-
stant.
7. Lower the contrast value until there is an initial change in brightness.
ð This is the optimum contrast value.
8. Exit the OSD to save the values.
ð You have set the brightness and contrast for optimized display of the 5% and 95%
squares of the SMPTE test pattern.
22
CuratOR LX1910
Instructions for Use, 08/2022